Introduction To The Installation Steps Of Bag Filter

When installing, please follow the steps below:
1. Place the bag filter at the work station that needs to be filtered, connect the inlet and outlet flanges or pipe teeth, and then fix them; block the exhaust port, or configure an exhaust valve. Jacket type connection to the heat source.
2. Gently put the metal inner mesh into the bag filter so that the collar of the inner mesh matches the mouth of the bag filter.
3. Place the filter bag so that the ring of the filter bag matches the collar of the metal inner mesh.
4. Put the O-shaped sealing ring into the O-shaped groove. The O-shaped sealing ring cannot be twisted or deformed. Fasten the filter bag pressure ring on the multi-bag filter machine.
5. Hold the handle of the upper cover with one hand and the other end of the upper cover with the other hand (turn the top handwheel of the multi-bag filter)
6. After the upper cover is aligned, tighten the two diagonal hanging caps at the same time, and tighten all the hanging caps one by one (insert a short stick into the lifting ring to tighten).
7. Close the exhaust valve installed on the top of the bag filter.
8. Please check whether the connecting pipes are firm and whether the working pressure is within the allowable range.
9. Open the output valve. Open the heat source inlet valve to raise the filter temperature to the specified temperature.
10. Open the input valve slowly, let the liquid slowly flow into and fill the filter, to prevent the liquid from suddenly impacting the filter bag and causing rupture, and then observe whether there is any leakage. If no leaks occur, filtration can begin.